ZES ZIMMER LMG450, User Manual

Page: 154 / 306

Interfaces (IEEE option L45-O1) LMG450
154
10.2.4.1.5.4.10 :RESult? FSRE? SrcOK
SCPI: :FETCh[:SCALar]:FLICker:SOURce:RESult? /qonly/ |
:READ[:SCALar]:FLICker:SOURce:RESult? /qonly/
SHORT: FSRE? /qonly/
ID: n/a Mode: Flicker
Type: long int Suffix: 1...4
Value: n/a List: n/a
Unit: n/a Group: n/a
Reads the result of the flicker measuring at the source.
Bit 0: Set if the total evaluation of the flicker fails (=if any of the sub evaluation fails). Cleared
otherwise.
Bit 1: Set if at least one P
st
value was >1.0, cleared otherwise.
Bit 2: Set if the P
lt
value was >0.65 at the END of the measuring interval, cleared otherwise.
Bit 3: Set if d
max
was bigger than limit, cleared otherwise.
Bit 4: Set if d(t) was >3% for more than allowed time, cleared otherwise.
Bit 5: Set if d
c
was > 3%, cleared otherwise.
10.2.4.1.5.5 :STATe? FSTA?
SCPI: :FETCh[:SCALar]:FLICker:STATe? /qonly/ | :READ[:SCALar]:FLICker:STATe? /qonly/
SHORT: FSTA? /qonly/
ID: n/a Mode: Flicker
Type: long int Suffix: n/a
Value: n/a List: n/a
Unit: n/a Group: n/a
Reads the state of the flicker measuring.
0: Reset
1: Wait
2: Run
3: Stop
10.2.4.1.5.6 :STRemain? FSTR?
SCPI: :FETCh[:SCALar]:FLICker:STRemain? /qonly/ |
:READ[:SCALar]:FLICker:STRemain? /qonly/
SHORT: FSTR? /qonly/
ID: n/a Mode: Flicker
Type: long int Suffix: n/a
Value: n/a List: n/a
Unit: s Group: n/a
Reads the remaining short time for the actual short term measurement.