10-64
IM 701310-01E
When the Search Type Is Width
Setting the Width Type, Time Span Mode, and Reference Time
2.
Press the
Setup
soft key.
3.
Press the appropriate mode soft key from
Pulse
to
State
to select the width type.
4.
Press the
Mode
soft key.
5.
Press the appropriate mode soft key from
More than
to
Time Out
.
6.
Use the
rotary knob
to set the reference time.
If you set the time span mode to Between or Out of Range, set two reference times.
Press the soft key to select the time that you want to set using the rotary knob.
7.
Press
ESC
to return to the previous screen.
T1
T2
More than,
Less than,
or Time Out
Between or
Out of Range
Proceed to the steps on the pages indicated below according to the width type selected
in step 3.
• If you select Pulse, proceed to step 8.
• If you select Pulse (Qualified), proceed to step 8 on page 10-65.
• If you select State, proceed to step 8 on page 10-66.
When the Width Type Is Pulse
• Selecting the Search Source Waveform and Polarity
8.
Press the
Source/Pol
soft key.
9.
Press the appropriate waveform soft key.
To select a channel from M1 to M4, press the
M1-M4
soft key first.
10.
Press the
Polarity
soft key to select Pos or Neg.
11.
Press
ESC
to return to the previous screen.
• Setting the Level and Hysteresis
12.
Press the
Level/Hys
soft key.
13.
Use the
rotary knob
to set the polarity reference level and hysteresis.
Press the soft key to select the setting that you want to set using the rotary knob.
ESC
Level
Hys
• Executing the Search
Carry out steps 6 to 14 in section 10.10.
10.11 Searching Waveform Signals
