FWX120 Operation Manual
185
8
If you cannot initialize
from the “Basic
configuration page”
If you cannot initialize the setting from the “Basic
configuration page” of the product, for example,
when you have set a wrong IP address of the
product, you can alternatively initialize the setting
using the PC connected to the console port, or
through button operation of the product.
Initialize from the PC connected to
the console port
1
Power off the product.
2
Connect the console port of the product
to the serial port of your PC with a serial
cable.
Please refer to page 146 for details on the
connection and setting of the PC.
3
Start the terminal software on the PC.
4
Power on the product.
The version of the ROM of the product is
displayed in the terminal software screen of
the PC, pending for pressing the Enter key.
5
Press the Enter key before the count
down of “Will start automatically in ...”
ends.
If the count down of “Will start automatically in
...” ends, the product will start with the normal
procedure. If the product has started, power off
the product once, wait for 10 seconds or more,
and then power on again to operate.
Troubleshooting
You can restore the product settings to their factory
defaults.
NOTE
When restoring the settings to their factory
defaults, be sure to note the following:
• All communications are disconnected immediately
after the restoration is performed.
• Any setting that has default value is changed to the
default value.
• Filter definitions and registered addresses are
deleted.
• Non-volatile memory contents are overwritten
without the save command.
• You cannot restore the original setting once the
operation is complete.
Tip
If you save the settings to an external memory
before initialization, you can restore the original
settings after initialization. Please refer to
“Checking the configuration information and log
of the product
” (page 160) for the procedure to
save setting.
Initializing from the
“Basic configuration
page”
If you want to restore the product settings to their
factory defaults, you can initialize the setting in the
“Restore default factory setting” screen.
For more details on the settings, click “Help” on the
setup screen and refer to the description displayed.
To open the “Restore default factory setting”
From “Basic configuration page”, click the buttons
on the setup screen in the following order:
“Advanced settings” in the top page
“Execute” of “Restore default factory setting”
Initializing the product settings
