Using an external
memory device
You can load a configuration file stored in a
commercially-available external memory device
(USB memory stick or microSD card) to the product
to change settings. This is convenient when you
want to change the settings of multiple units of
the product.
NOTE
• External memory devices used for the product must
be formatted in FAT or FAT32.
• You cannot use a USB hub to connect two or more
USB memory sticks or other external memory
devices to the product.
• Some types of USB extension cables may not be
able to work normally. Use the USB memory stick by
inserting it directly into the USB port of the product.
• Do not remove the external memory device while
the USB lamp or microSD lamp of the product is lit
up or flashing. Doing so may damage data in the
external device. Before removing the external device,
hold down the USB button or microSD button for
two seconds and make sure that the USB lamp or
microSD lamp has gone off.
Change settings so that the configuration
file in the external memory device can be
loaded to the product
In the “Startup via external memory” field on the
“Configure external device” screen, select “do not
allow”. Also in the “Configuration file name” field,
specify the name of the configuration file to be
copied to the product.
To open the “Configure external device” screen
From “Basic configuration page”, click the buttons
on the setup screen in the following order:
“Advanced settings” in the top page
“Configure” of “Configure external device”
FWX120 Operation Manual
147
7
Operating and managing the product
Press the button on the product front
panel to load a configuration file
1
Prepare an external memory device
storing a configuration file.
Specify the same file name as that specified
in the “Configuration file name” field on the
“Configure external device” screen.
2
Insert the external device into the USB
port or microSD slot of the product.
The USB lamp or microSD lamp of the product
lights up or flashes.
3
While holding down the USB button
or microSD button, hold down the
DOWNLOAD button for three seconds.
The configuration file prepared in Step 1 is
loaded to the product. After the file has been
loaded, the product restarts automatically.
After the restart, the product operates using
settings of the loaded configuration file.
NOTE
If “allow” is selected in the “Startup via external
memory” field on the “Configure external
device” screen, the product starts by using the
configuration file in the external memory device.
In this case, do not remove the external device.
Tip
If a firmware file having the name specified in
the “Firmware file name” field on the “Configure
external device” screen is included in the external
memory device, the firmware file begins to be
copied to the product continuously.
4
Hold down the USB button or microSD
button for two seconds.
The USB lamp or microSD lamp of the product
goes off.
5
Remove the external memory device.
NOTE
If loading the configuration file from the external device
fails, refer to “Unable to use USB device” (page 178).
Changing the product settings
(Continued from the previous page)
