Required settings
For remote access, the product or a PC needs to
be configured as shown below.
Configuring the product
• Configure the broadband connection.
- The WAN or PP side of the product must be
assigned a global IP address.
- For the terminal connection in which WAN or
PP address is dynamically assigned, it will
be necessary to obtain host names that are
available using the netvolante DNS service
(page 131).
- For the network connection, check the global
IP address that is assigned to the WAN or PP
side of the product.
• Register connection destinations (next section).
Settings required for a server or PC
in the LAN
• Configure a fixed private IP address.
• Change the settings of the file server software.
Settings required for a PC for remote
accessing
• Changing the configurations of a PC that is
remotely accessed (pages 119 and 122).
Registering connection
destinations
Register connection destinations.
NOTE
• Up to 50 users can be registered for PP connection.
There are up to 50 PPTP tunnel connections at a time,
including the ones used in anonymous connections.
• Although any number of users can be registered with
anonymous connections, there are up to 50 PPTP
tunnel connections at a time, including the ones used
in PP connections.
1
On the top page of “Basic configuration
page”, click “Advanced settings”,
then click “Configure” to the right of
“Configure VPN connection”.
2
Click “Add ” to the right of the destination
you want to register.
FWX120 Operation Manual
117
5
Implementing site-to-site VPN connections
