7
E
5. Adjust:
• Throttle cable joint position
Adjustment steps:
• Turn the throttle grip to the fully closed
position.
• Turn the magneto control lever
1
so that
its adjusting screw contacts the fully
retarding stopper
a
.
• Adjust the position of the cable joint until
its hole aligns with the set pin.
• Install the clip
2
, and then tighten the
locknut
3
.
WARNING
The cable joint must be screwed in a
minimum of 8.0 mm (0.31 in).
NOTE:
Put the “UP”
b
mark upward.
6. Check:
• Fully open position
Incorrect
→
Adjust.
Checking steps:
• Turn the shift lever to the forward position.
• Turn the throttle grip fully open.
• Check that the throttle valve lever so that it
contacts the fully opened stopper.
TillerHandle.book Page 7 Friday, April 12, 2013 3:19 PM
