Xerox Document Centre 505 Series, User Manual

Page: 29 / 269

Overview of the Printer
13
1.6 Setting IP Address for
Network Environment
This section explains how to set the IP address .
Depending on the network environment, you may need to set the subnet mask and gateway address . If
your network has a Dynamic Host Configuration Protocol (DHCP) or BOOTP environment, the printer
can obtain these items automatically from each of the server.
By the factory setting, these items are obtained automatically from the DHCP server.
• Use the DHCP server together with the Windows Internet Name Service (WINS) server at the same time.
• When using the BOOTP server, specify the settings by referring to "1.6.2 Using touch panel display
for setting" as a guide but changing the procedure as follows:
(1) Follow Steps to to display the screen for setting TCP/IP: IP Address.
(2) Select Auto Obtain (BOOTP) instead of Specify Address for Step , and then touch Save .
(3) Follows Steps and to reboot the machine.
Check with your system administrator if you have any queries on the BOOTP environment.
1.6.1 Flow of setting
When the IP address is obtained automatically from the DHCP or BOOTP server, you do
not need to follow the procedure in this section to set the IP address.
When you need to set the IP address manually using the control panel, refer to "1.6.2
Using touch panel display for setting".
When you are unsure whether you have a DHCP server, follow the procedure below to
check. If you do not have a DHCP server, set the IP address by referring to "1.6.2 Using
touch panel display for setting".
Checking DHCP server