Xerox Document Centre 505 Series, User Manual

Page: 150 / 269

134
9.1 Introduction
9.1.3 Other setting items
If necessary, define the following items related to IPP on the CentreWare Internet
Services screen (Properties tab > Protocol settings > IPP). However, there is no need to
change the factory setting of these items for normal usage.
• IPP Port Number (Factory setting: 80)
• IPP Print Mode (Factory setting: PCL*)
• IPP PJL Switch (Factory setting: On)
• IPP TBCP Filter (Factory setting: Disable)
• IPP Access Control(Factory setting: Disabl e)
• IPP DNS (Factory setting: Disable)
• IPP Connection Time-Out (Factory setting: 60 sec)
• IPP Spool(Factory setting: Hard Disk spool )
• These settings cannot be defined at the printer touch panel display.
• * If the optional PostScript software kit is installed, factory setting will be Auto.
• Port Number is the port number used for receiving data. It is fixed at 631 and for
additional port, you can define the number as 80 or between 8000-9999. If you
assign 0 as the port number, the added port will not be enabled. This setting is
effective after the printer is rebooted.
• With IPP, you can store the print data output from the application in the spool file
of the printer temporarily to be processed for printing. Set the spool mode by using
the IPP spool of the receive buffer capacity.
Spool mode:
The mode which stores print data output from the application in the spool file of
the printer temporarily to be processed for printing. You can choose to save the
spool file in either the RAM disk which has used the printer memory or the hard
disk connected to the printer. As the processing of print data after spooling will
be done in the printer, the application in the client is soon released. Requests
from multiple clients can be processed at the same time.
Non spool mode:
The mode which processes printing while the print data output from the
application is being received by the printer. When the printer is processing
printing request from a client, printing request from other clients cannot be
received.
• The maximum spool number is 1,000. However, depending on the empty capacity,
you may spool up to 200 only.
For non spool mode, if job is sent when the printer is in sleeping mode, the buffer may
become full and the printing request may not be completed. When this happens,
deactivate the sleeping mode of the printer and the printing request will be
completed.