Xerox Document Centre 505 Series, User Manual

Page: 111 / 269

Setting
Up
for
TCP/IP
(Windows
NT/Windows
2000
)
95
$
This section describes the procedure to set the LPD port to Enable (factory setting: Enable).
The protocol used by the transport layer is TCP/IP.
When setting the port to Enable leads to insufficient memory, a message about the insufficient memory
may be displayed on the control panel and the port status may be set to Disable automatically. If this
happens, set the ports which are not in use to Disable and change the memory size.
6.2.1 Setting the LPD port to Enable
Follow the procedure below to set the LPD port to Enable. Once the LPD port is enabled,
the protocol and the IP address can be set. If necessary, set the subnet mask and the
gateway address.
Procedure
Press the Settings/Meter Check button on the control panel and select Tools
Mode on the screen displayed.
Enter the access number of the system administrator and touch Confirm.
The factory setting of the access number is "11111".
6.2 Setting Up the Printer