Xante FilmMaker 4, User Manual

Page: 257 / 310

Options 7-13
b. Slide the power cord up through its opening in the bottom of the
controller assembly, making sure to align the cord’s purple ground wire
to the right (below the minus (-) sign) and the cord’s purple wire is to the
left (below the plus (+) sign); then, gently guide the cable’s end (pin side
down) straight into its connector on the controller board until the end
seats firmly. Then, if a power cord ferrite was on your printer, put it back
on the power cord, making sure the latch closes completely (fig. 7.15).
c. Turn the front panel display cable so that the metal pin side of the end
faces out from the printer. Slide the end down through the top right
corner opening on the controller assembly frame; then, gently guide the
cable’s end (pin side down) straight into its connector on the controller
board until end seats firmly.
d. Slide the controller assembly into place on the printer’s left side and press
the area above the video connection to secure the connection.
e. Replace the six screws securing the controller assembly to the printer
(fig. 7.14).
3. Replace the front side cover.
a. Align the cover’s two bottom tabs and two top latches with their
corresponding slots on the printer (fig. 7.13).
b. Insert the bottom tabs first, and then swing the top latches up into place.
4. Replace the front cover.
a. Tilt the cover to the side just above the printer and to the left (fig. 7.12).
b. Reconnect the front panel display cable (fig. 7.12), making sure the foil
side of the cable’s end faces the pin side of the connector on the front
panel cover.
c. Turn the front panel cover upright and lower it down into place on the
printer, making sure to align the securing holes on the cover and printer.
d. Replace the two front panel securing screws (figs. 7.10 and 7.11).
e. Close the fuser cover; then close the printer’s top cover, making sure it
latches into place (fig. 7.9).