Xante FilmMaker 4, User Manual

Page: 158 / 310

3-46 PC Setup
EtherTalk Configuration
On an EtherTalk network with more than one zone, the network router assigns your
printer a default zone. Check with your System Administrator to determine the
correct zone for your printer; then, if necessary change the printer’s zone name. Also,
if more than one printer of the same model is on the Ethernet network, you may want
to change the printer name to avoid confusion or just to personalize the printer.
To configure EtherTalk settings
1. Go to the printer home page (fig. 3.95). See “Printer Home Page” earlier in this
chapter for details.
Fig. 3.95 Printer Home Page Fig. 3.96 EtherTalk Configuration Window
2. Select Printer Configuration: Network: EtherTalk (fig. 3.95). The EtherTalk
Configuration window appears (fig. 3.96).
3. Enter the desired name for the printer (fig. 3.96); for example, you might name
the printer Samson. Then, click Change to the right.
4. Enter the new name for the EtherTalk Zone Name (fig. 3.96). Then, click
Change to the right.
EtherTalk zone names are limited to 32 characters, are not case sensitive, and cannot
include the = (equal),
≅
(approximately equal), * (asterisk), : (colon), or @ (at)
characters.
5. Close your browser.
General Network Configuration
The General configuration option allows you to set the network buffers.
1. Go to the printer home page (fig. 3.97). See “Printer Home Page” earlier in this
chapter for details.