
Options 7-3
7.
Insert the screws supplied with the feeder into the holes on the bottom of the
printer (fig. 7.3). Tighten the screws to secure the feeder to the printer.
8.
Unpack the cassette, load it with paper, and install the first and second cassettes
according to procedures in chapter 1 (fig. 7.4).
Fig. 7.4 Install Second Paper Cassette
Removing the Paper Cassette Feeder
1.
Make sure the printer displays a Please Wait or Ready/Idle message. Then, turn
off the printer and disconnect the power cord from the power supply.
2.
Remove media from the multipurpose feeder and the output tray; then, close
the multipurpose feeder.
3.
Remove all paper cassettes from the printer. Pull each cassette out until it stops.
Lift up slightly and remove it from the printer.
4.
Remove the screws that secure the feeder to the printer (fig. 7.3).
The printer weighs approximately 58.5 lbs (26.5 kg)
without
toner, cassettes, and
media installed. Always have two people lift the printer using the recessed grip areas
on the right and left sides.
5.
Lift the printer off the feeder vertically until the printer is free of the feeder’s
stubs (fig. 7.2). Set the printer on a stable surface that will support its weight.
6.
Repack the feeder in its original box and store it in a location that meets the
guidelines in “Printer Location” in chapter 1.
7.
Set the printer up again following the instructions in chapter 1.
Summary of Contents for FilmMaker 4
