Xante FilmMaker 4, User Manual

Page: 219 / 310

Configuration 4-23
To adjust the print density dial
1. Open the multipurpose feeder by grasping the handle in the top center of the
cover and pulling down (fig. 4.12).
The multipurpose feeder does not open to a 90
°
angle. To prevent damage to the
feeder, do not exert strong pressure or place heavy objects on it.
Fig. 4.12 Open Multipurpose Feeder Fig. 4.13 Adjust Print Density Dial
2. Turn the print density dial toward the H (Higher density) to darken the print
or toward the L (Lower density) to lighten the print (fig. 4.13).
3. Close the Multipurpose Feeder.
Check the print density dial when you replace a toner cartridge. The setting required
for the previous cartridge may be too high or too low for the new cartridge.
Toner Page
The Toner Page feature automatically prints a toner reorder form when the cartridge
needs to be replaced. To order a new cartridge, fill out the form and return it to
XANTÉ or to your XANTÉ vendor. If the feature is enabled and toner is low, the
reorder form prints every 250 pages.
Set Toner Page from the Utility: Toner Page configuration menu. Yes, the factory
default, enables this feature; No disables it.
Tray Selection Options
You can select a specific tray as the default media source or you can use tray chaining
to automatically switch to another source for media when the current source is empty.