Xante FilmMaker 4, User Manual

Page: 250 / 310

7-6 Options
To install a memory upgrade
1. Access the controller board following the procedure in “Removing the
Controller Board Panel” earlier in this chapter.
2. Remove the SODIMM from its package.
3. Open the end latches on the RAM memory bank by rotating them out and
down (fig. 7.8).
Fig. 7.8 Open Bank Latches
If this is not the first memory upgrade, you must remove the initial upgrade from the
memory bank before installing the new upgrade. When you open the bank latches the
old upgrade pops up automatically; lift it straight up and out of the bank.
4. Install the new RAM SODIMM (fig. 7.8).
a. Align the RAM SODIMM straight above its bank, making sure the
SODIMM’s notches are positioned over the corresponding IDE board
connector’s notches.
b. Lower the SODIMM straight down into its bank until the bank latches
snap into place.
Do not force a SODIMM into place. If it does not go in easily, realign it making sure
its notches are positioned correctly; then, lower the SODIMM into place (fig. 7.8).
5. Reassemble the printer following the procedure in “Reinstalling the Controller
Board Panel” later in this chapter.