Woodward SEG HighPROTEC MRA4, Device Manual

Page: 75 / 510

Smart View
Smart view Troubleshooting
•
Make sure whether the Windows service Telephony is started. In [Start>System Control >Administration
>Services] the service »Telephony« must be visible and must have also been started. If not, the service
has to be started.
•
For establishing the connection, you need to have sufficient rights (administration rights).
•
If a firewall is installed on your computer, TCP/IP port 52152 must have been released.
•
If your computer is not provided with a serial interface, you need a USB-to-serial-adapter , accepted by
Woodward SEG . This adapter has to be properly installed.
•
Ensure that a zero-modem cable is used (a standard serial cable without control wires does not enable
communication).
If on a »WINDOWS XP computer a serial interface for direct connection to
another computer has not been established so far, the following problem
can arise:
If you have selected a serial interface in the connection assistant, it may
happen that this is not entered correctly in the dial-up network due to an
bug in the Windows operating system. Your attention is drawn to this
problem by the operational software and the error message »Warning,
invalid connection setting« will be shown.
To solve this problem, you need administration rights.
Please proceed as follows:
•
Select menu point »Device Connection« in menu »Settings«.
•
Select »Serial Connection«.
•
Click button »Settings«.
•
Change to register card »General«.
•
Ensure that »Communication cable between two computers (Com X)“ is
selected in the »Drop Down Menu«. »X« = interface number where you
have connected the zero-modem cable to.
EN MRA4 04/09 Page 75