![background image](http://html1.mh-extra.com/html/warema/climatronic-control-panel-3-series/climatronic-control-panel-3-series_installation-and-connection_3373670038.webp)
2017717_b•en•2016-11-01
We reserve the right to make technical changes
38
WAREMA climatronic® 3.x
Installation and connection
7.6 im actuator 2 DP/EGN
Dim actuator 2D (300 VA for vertical installation, 200 VA for horizontal instal-
lation, see Technical Data and Fig. 3) is an electronic control device for sup-
plying all standard light sources and fan motors with power.
Permissible loads:
Incandescent bulbs and high voltage halogen lamps
Dimmable energy saving lamps
Fan motors
Electronic transformers
Conventional (wound) transformers
Combination of incandescent bulbs and electronic transformers
Combination of incandescent bulbs and conventional transformers
Impermissible loads:
Lamps and fans that already have a dimmer
Electric devices that are not among the loads specified above
Combination of electronic and conventional transformers, since these require
different dim types
To prevent damage to the connected motors, the default settings are such
that only one relay is activated at a time and connected single push buttons
operate in dead man's mode. Group buttons and locking contacts are
functional after the actuator has been commissioned.
Install the actuator as described in
chapter 4.4 on page 15
.
In addition note the following figure.
Vertical installation
max. 300 VA
Horizontal installation
max. 200 VA
Fig. 20
Installation of dim actuator 2D
Use the
wiring diagram on page 39
to connect the actuator.
Also note the
chapter 5.6 Dimensioning of the power supply on page 30
,
as the actuator must be supplied with 24 V DC.