2017717_b•en•2016-11-01
We reserve the right to make technical changes
11
4 Nnstallation
DATNIA
The control and its auxiliary components may only be operated when
installed or at the specified installation locations.
Malfunctions or dangerous situations may occur at the unit if this is
neglected. If this is the case, any guarantee or warranty claim becomes
void.
4.1 Procedure during installation
Follow the points below in the order given:
1. Determine the installation location of the individual compo-
nents
Refer to the specifications in
chapter 3.2 Network on page 10
,
chapter
5 Connection on page 16
and in the sensor and switch actuator data
sheets.
2. Determine the lines required for connecting the components
to each other
Use the information given in
chapter 5 Connection on page 16
.
Be aware that terminal sets of multi-pole products must be connected to the
same terminal block of a switch actuator and not to two separate ones.
3. Install components
The last page of the switch actuator instructions contains tables for
noting down the terminal assignments. This is absolutely essential for the
future software-specific allocation on the control panel of the WAREMA
climatronic®. Also affix an ID sticker of the actuator on the field provided
for this purpose and note down the installation location and any other
information about the device that may be available.
4. Install required lines
5. Continue with
chapter „5 Connection“
