2017717_b•en•2016-11-01
We reserve the right to make technical changes
26
WAREMA climatronic® 3.x
Installation and connection
5.5.2 Fault alarm contact
WAREMA climatronic®
Schaltaktor 6M oder 6M230
F2 6,3
AT
H
F3 6,3
AT
H
N
L
PE
green (OK)
red (fault)
Fig. 14
Connection example for fault alarm contact
When de-energised (idle state) and if there is a fault, the "Fault" contact is
closed. When there is no fault, the relay is activated and the contact A 6.2
closes.
The fault alarm contact can only be connected to a 6M or 6M230 switch
actuator (A 6.2/fault). This actuator must be set up as actuator 1 in the
WAREMA climatronic® project.
During commissioning, one channel must be reserved for the product fault
alarm contact .
The fault alarm contact is activated when:
Operating voltage failure
Bus communication fails
An actuator fails
Failure of control panel, weather station sensor Inside temperature/
Humidity
The E 6.2 input does not have a function in this circuit and must not be used.
The 4M and 4M230 switch actuators do not have a fault alarm contact.
