WAGNER Titanus Micro-Sens, Technical Manual

Page: 158 / 238

Installation Pipe System
TITANUS
MICRO·SENS
®
158 06/13
Noise suppressor
C
TITANUS MICRO·SENS ®
SD-1
Figure 100: Mounting of noise suppressors
1. Pass the pipe (∅ 25 mm) through the opened feed-through in the protec-
tion grid and fix it with the existing pipe collar in the air outlet of TITA-
NUS
®
. As the air return pipe fits exactly into the exit air opening, a tight
fit is ensured.
2. In order to connect the aspiration pipe with the noise suppressor please
insert the aspiration pipe into the designated pipe connectors of the
noise suppressor.
3. When installing the absorbing duct, ensure that the direction of air flow is
shown at the side of the housing’s bottom part.
4. Screw the bottom part of the housing directly to the wall.
NOTICE
Never use glue to connect the air sampling pipe and pipe connectors.
If severe variations in temperature are expected, then it is required to fix
the pipe right before the air filter in order to avoid elongation ( See chapter
installation of the pipe system “Linear expansion of the pipe system” ) of
the pipe and therefore possible loss of pipe connectivity (pipe contraction).
Noise suppressor Cylinder or flat-head screws
– thread diameter: max. 4 mm
– head diameter: 5 to 7 mm
7.8
Installation material