VooDoo DCR 6000, Planning & Installation Manual

Page: 69 / 149

3. Installation DCR 6024/6128/6000
3 – 16 Planning and Installation – Rev. 1 / 7. 2001
3.4.6 INSTALLING THE CONTROL PANEL AS LOCAL PANEL
Control Panel installation at the Tapedeck for local operation
For local operation, the Control Panel is mounted at the front of the Tapedeck as
follows:
1. Open the mounting locks at the upper left and right side of the Panel (fig. A.1)
by counterclockwise rotation with an appropriate screwdriver or a coin.
2. Push the locking buttons at the lower left and right side of the Panel (fig. A.2)
and keep them pushed. Place the panel in the mounting brackets (oblique
downwards) (fig. B.3). Release the locking buttons and slightly tilt the Control
Panel up until the locking bolts lock in one of the holes (fig. B.2) of the mounting
brackets on both sides.
3. Bring the mounting locks (fig. A.1) into the holes (if necessary, slightly move
the Control Panel up and down) and tighten them by clockwise rotation.
4. Connect the panel at the 15-pin socket and fasten the connector (fig. C.1) with
a small screwdriver.
1
1
3
2
2
Tapedeck
A
B
C
Fig. 313: Mounting the control panel