VooDoo DCR 6000, Planning & Installation Manual

Page: 116 / 149

5. Startup DCR 6024/6128/6000
5 – 5 Planning and Installation – Rev. 1 / 7. 2001
5.3 SELECTING MACHINE ADDRESS
If several machines are to be operated in a cluster configuration using the iMCS
interface, each machine in the cluster must have its own address (1 - 4) which is
indicated in the door display on the left hand side below the video cassette compart-
ment.
1. Switch off the DCR 6024/6128/6000 and disconnect it from the mains.
2. Open the front door of the Tapedeck as follows.
Loosen the two screws on the left hand side of the front door with a hex socket
wrench (opening 2.5) and open the door to the right.
The p.c. boards are now visible.
3. Set the hex-decimal switch (iMCs address selection) on the upper board
BY 5160 (System Control) to the desired position ”0, 1, 2, 3” (Fig. 504).
Setting 0 = machine address #1
Setting 1 = machine address #2
Setting 2 = machine address #3
Setting 3 = machine address #4
4. After the machine address has been selected, close the front door, connect the
mains and switch the machine on.
Now, the selected machine address (for example ADDR #1) is shown in the door
display on the left hand side below the video cassette compartment.
iMCS address selector
1
2
3 4 5 6
7
8
9
A
B
C D
F
E
0
XX
System
Control
BY 5160
HW
Philips Eq. 10015661
Mat. 000164772900
XX SW
Fig. 504: Address selector