VooDoo DCR 6000, Planning & Installation Manual

Page: 118 / 149

5. Startup DCR 6024/6128/6000
5 – 7 Planning and Installation – Rev. 1 / 7. 2001
The machine output signal can be delayed or advanced with respect to the refer-
ence signal over a range of 4.85
µ
s in the horizontal position and delayed by –12
and advanced by +4 lines in the vertical position.
By pressing the function key F6 ”Setup, ADJUST” in the VIDEO menu, the horizon-
tal and vertical signal positions in the H and V-delay window may be matched with
that of the reference signal position using the Adjust Dial on the Control Panel (refer
to operating instructions section 4.11.3 ”Setup Analog Adjustments”).
External delay times of the audio signals, compared to the video signals as a result
of e. g. audio effect devices (advance: 0 - 10ms) can be compensated as well as
matching of e. g. video delay times from frame buffers (delay: 0, field, frame) in the
Audio Config menu with window ”Setup Output Timing” (please refer to Operating
Instructions section 4.8.4.).
5.4.2 DATA MODE
When the system is configured as data recorder, a check of input signal an HIPPI
communication is recommended.
The HIPPI protocol requires both optical paths to be connected (send/receive) in-
dependent of play or record mode.
Because some optical cables have no indication of input and output this check is
required for proper operation. The indicator for correct configuration is the DATA
INPUT indicator.
If the cable set up is correct, the data input indicator will be off.
If the data recorder is connected via an HIPPI router, the destination address has
to be set up prior to manual operation of the data recorder. The destination address
(I–field in HIPPI protocol) can be selected in the home menu. See Operation
manual for details.
Studio Timing
(timing delay)
Audio Timing