VooDoo DCR 6000, Planning & Installation Manual

Page: 112 / 149

5. Startup DCR 6024/6128/6000
5 – 1 Planning and Installation – Rev. 1 / 7. 2001
5. STARTUP
This chapter describes startup of the DCR 6024/6128/6000, including the follow-
ings sections:
Installation check
Switching on
Selecting HD standard / data mode
Selecting machine address
Control of the reference signal / input data
Operation
Note:
For initial installation of the DCR 6024/6128/6000, observe the order of follow-
ing sections!
5.1 INSTALLATION CHECK
1. Ventilation
Take care that incoming and outgoing air can circulate free.
See also chapter 5.3 ”Ventilation”.
2. Internal connections
Check the internal connections 1 to 7 and the iMCS-switches 8 to 9 according
chapter 5.5 ”Standard Connections”.
3. Grounding
The mains cable, however, must be plugged into an earthing-contact type
socket only.
Details see chapter 4.5.1.1 ”Grounding of the Tapedeck” and
4.6.1.1 ”Grounding of the Processor”.
4. Power switch
The Power switch of the Data–Processor on the rear side must be set to on
(position ”1”).
The Breaker of the DTV–Processor on the rear side must be set to the upper
position.