
Display, Keys and Menus
The Function Menu
VT200/220 Technical Manual, Rev 1.00.01
27
Doc
#
TM-VT200/220-EN
3.3.1
Using the Function Menu
To access a function on the function menu:
1. Press
TARE
( ) on the front panel, and keep it pressed for around three seconds.
The display shows
Fn 00
. The left digit should be flashing.
2. Check the number of the function you need (refer to Function Summary list below).
If the function you need is between 01 and 09, skip to step 4.
3. Press
u
(
P.TARE
) to increment the left-hand digit (tens). Keep pressing it until it
matches the function you need. For example, if you need function 43, press
u
four
times. The left digit should become
4
.
4. Press
t
(
TARE
) to move to the right-hand digit (units). This digit should start
flashing.
5. Press
u
(
P.TARE
) to increment the right-hand digit (tens). Keep pressing it until it
matches the function you need. For example, if you need function 43, press
u
three
times. Assuming you entered 4 for the left-hand digit, the display should now show
Fn 43
.
6. Press
(
) to confirm. The operation associated with the function number you
entered is performed.
3.3.2
Function Summary
Function Description
Refer to
01
Edit setpoints.
The display shows
SEtP 1
briefly, then the current setpoint
value.
Use
u
(
P.TARE
) to change the current digit, then
t
(
TARE
) to move to the
next digit.
When you are done, press
(
).
The display shows
SEtP 2
briefly, then the current setpoint value.
Edit the second setpoint value using the same procedure.
Chapter 7
02
Display battery status.
The display shows the current battery charge, as a
percentage of total capacity.