DOC: BURN-IN STATION
DESC: Burn-In Test Procedures
PAGE:
REV
4 of 12
1
PREPARED BY: Sax Makthepharack REVISED BY:
CONTROL: INDUSTRIAL ENGINEERING
REV. DATE:
SHOWN
-
10 - 17 - 00
Bob Jolley
1.2.7
Turn the 3900 power switch on.
1.2.8
If the last 4 digits of the serial number, of the 3900 being tested, are already in the Host Name block, skip the next step.
1.2.9
After new data appears on a line in the table, click the box under and replace <unnamed> with the last 4 digits of the
3900 serial number and push enter on the keyboard. Delete lines of data in the table that correspond to instruments no longer connected
to the burn-in computer. This is done by clicking a box with data in
it, and then clicking delete. Next, click .
1.2.10 Click the button, of an Address not being used.
CLICK HERE
STEP 1.2.9
CLICK HERE
STEP 1.2.10
CLICK HERE
STEP 1.2.7
CLICK HERE
STEP 1.2.9
