DOC: 03-933001-01
DESC:
Assy, Basic Electrical, (120v Shown)
PAGE:
REV
5 of 23
1
PREPARED BY: Sax Makthepharack REVISED BY:
CONTROL: INDUSTRIAL ENGINEERING
REV. DATE:
SHOWN
-
07 - 18 - 00
Dave Maderos
1.2
CIRCUIT BREAKER/WIRING HARNESS INSTALLATION
1.2.1
Route 1/4" quick-connect lugs of appropriate circuit breaker harness, 03-933504-01 (for 120VAC) 03-933505-01 (for 101/230VAC) through
innermost hole of the rear chassis panel as shown.
1.2.2
Route the RED/GREEN LED and magnetic sensor of Door/LED harness, 03-933509-01 through outermost hole of the rear chassis panel
as shown.
1.2.3
Install a split grommet, 24-799873-00 over the circuit breaker harness and snap into outer oven rear chassis panel as shown. Repeat this
step for the Door/LED harness.
1.2.4
Install the appropriate circuit breaker: 55-700713-00 (for 120VAC); 55-700714-00 (for 230VAC); 55-700715-00 (for 101VAC) into power
switch housing, 03-925210-01 as shown. Secure using special wrench T# 8983.
1.2.5
Plug 1/4" quick-connect lugs from circuit breaker harness onto circuit breaker. Note that the numbered label on the lug matches the
number on the circuit breaker. Make sure circuit breaker is in the OFF (0) position.
1.2.6
Position the chassis assembly, 03-933010-01 on its back and secure power switch housing, 03-925210-01 to chassis using two each
8-32 X 3/8" screws, 12-901163-00 as shown.
1.2.7
Obtain lower front panel, 03-933178-01 and snap in two each LED mounting clips, 67-599272-00 in the holes labeled "POWER" and
"FAULT".
1.2.8
Place one LED mounting collar over each of both the red and green LED’s of the Door/LED harness, 03-933509-01. Snap the green LED
into the mounting clip in hole labeled "POWER" and secure LED with mounting collar. Snap the red LED into the mounting clip in hole
labeled "FAULT" and secure with mounting collar.
1.2.9
Route the magnetic switch from the Door/LED harness out the right side of the lower front panel, 03-933178-01 and secure panel to
chassis using three each 8-32 X 1/4" screws, 12-901165-00.
Continue Next Page
