DOC: 03-933001-01
DESC:
Assy, Basic Electrical, (120v Shown)
PAGE:
REV
9 of 23
1
PREPARED BY: Sax Makthepharack REVISED BY:
CONTROL: INDUSTRIAL ENGINEERING
REV. DATE:
SHOWN
-
07 - 18 - 00
Dave Maderos
1.4
TRANSFORMER/LINE FILTER/VENT STEPPER MOTOR/WIRING HARNESS INSTALLATION
1.4.1
Working from the rear of the chassis, install fan motor channel, 03-933170-01 onto rear oven chassis panel using eight each 8-32 X 1/4"
screws, 12-901165-00 as shown.
1.4.2
Obtain appropriate transformer, 03-933500-01 (for 120VAC) 03-933501-01 (for 230VAC) and 03-933502-01 (for 101VAC). Secure
transformer to chassis using four each 10-32 X 3/8" screws, 12-901130-00 and four each #10 flat washers, 14-122010-00 as shown.
1.4.3
With an 11/32" nut driver secure the ground wire (labeled "E2") on the circuit breaker harness to the chassis ground stud next to the
transformer using a #8 kep nut, 13-312008-00.
1.4.4
Obtain line filter, 03-925594-01 and remove the first nut and all the washers from each of the four AC studs. Using a 11/32" nut driver
gently tighten down the remaining nuts.
1.4.5
Attach the AC input cable, 03-933503-01 to the side of the line filter labeled "LINE" using two of the previously removed flat washers and
two each #8 kep nuts, 13-312008-00 as shown.
1.4.6
Secure the blue and brown wires from the circuit breaker harness to the side of the line filter labeled "LOAD" using the same hardware
referenced in the previous step.
1.4.7
Mount the line filter to the chassis using two each 8-32 X 1/4" screws, 12-901165-00 as shown.
1.4.8
Plug 1/4" quick-connects from the AC input cable, 03-933503-01 into line cord receptacle, 51-340093-00 as shown. Snap receptacle into
chassis.
1.4.9
Secure ground wire from AC input cable to stud on chassis using one each #8 kep nut, 13-312008-00.
1.4.10 Route connector of vent stepper motor, 03-925306-01 through the rectangular opening on top of chassis. Place split grommet,
24-799873-00 over motor wires and snap into chassis.
1.4.11 Secure stepper motor to chassis using two each 6-32 X 3/8" screws, 12-901161-00.
Continue Next Page
