DOC: 03-933008-00
DESC: Assy, Front Door
PAGE:
REV
3 of 3
1
PREPARED BY: Sax Makthepharack REVISED BY:
CONTROL: INDUSTRIAL ENGINEERING
REV. DATE:
SHOWN
-
06 - 12 - 00
Dave Maderos
1.
FRONT DOOR ASSEMBLY PROCEDURES
1.1
BRACKET ASSEMBLY
1.1.1
Install two Roll Pins, 19-224776-00 on both sides of the Latch Release, 03-933159-01 using Press Tool until pins bottoms out.
1.1.2
Install two Teflon Flat Washers, 14-999408-00 onto the Roll Pins previous installed and install Strike Plate, 03-933157-00 onto roll pins as
shown. It is OK to flex Strike Plate slightly during this installation. Do not permanently distart strike plate!
1.2
STRIKE PLATE ASSEMBLY INSTALLATION
1.2.1
Install the
obround
Vibration Isolator, 03-933186-03 approximately 3/4” from the top
of the Latch Release using Double Side Tape, DY-700098-00. Excess tape can be trimmed
with an exacto knife.
1.2.2
Secure the Strike Plate Assembly onto the GC Front Door, 03-933156-01 using four
8-32 x 1/4 Sems Screws, 12-901165-00 as shown. Check that latch release operates smoothly
and does not scrape against front door opening.
1.3
MAGNETIC SENSOR INSTALLATION
1.3.1
Using a 3/16” nut driver, install Actuator Magnetic Proximity Sensor, 71-300053-00
onto the front door, using two 4-40 x 1/4” Hex Standoffs, R0-08000-55 as shown.
1.4
COLUMN OVEN DOOR ASSEMBLY INSTALLATION
1.4.1
Install two each Oven Door Springs, 03-933160-01 onto the column oven door assembly using four each Blind Rivets, 17-699907-00 two
each as shown.
1.4.2
Place one end of the oven door spring on the stud mounts of the front door. Flex on opposite ends of the oven door spring with your fingers
and place the oven door spring onto the other two stud mounts.
1.4.3
Install two 1/8” Snap In Nylon Sleeve Bearings, 21-139978-00 into a holes on the end of the oven door where shown.
ISOLATOR INSTALLATION (REF.)
3/4” (Ref.)
