DOC: 03-933012-00
DESC: Assy, Column Oven Motor
PAGE:
REV
3 of 3
1
PREPARED BY: Sax Makthepharack REVISED BY:
CONTROL: INDUSTRIAL ENGINEERING
REV. DATE:
SHOWN
-
08 - 21 - 00
Dave Maderos
1.
COLUMN OVEN MOTOR ASSEMBLY PROCEDURES
1.1
OPERATION IN SEQUENCE - Note: This operation should be performed in a well ventilated area and assembler should wear
rubber gloves.
1.1.1
Prior to assembly, clean Column Oven Motor and Motor Mount Brackets with IPA.
1.1.2
Obtain proper Column Oven Motor, 03-925307-0X depending on application, place motor shaft into center hole of the Fixture
T-8981 and position the wires toward the left with two cutout toward you as shown in motor assembly top view.
1.1.3
Apply a thin coating of DC #732 RTV Adhesive, 88-299671-00 on the motor where the rectangular cut-outs on fixture are
located. Place three each Vibration Isolator, 03-933186-01 onto motor. Using the cut-outs in fixture for proper orientation.
Make sure isolator is completely coated with RTV.
1.1.4
Apply a thin coating of DC #732 RTV Adhesive inside both Motor Brackets, 03-933177-01. Assemble Motor Brackets onto the
fixture stud mount, make sure Isolators are properly aligned prior to securing with four 6-32 x 1/4 Sems Screws,
12-901135-00 as shown.
1.1.5
Obtain Connector Housing, 51-406932-00 and referring to CONNECTOR WIRING TABLE on page #2, install motor pins into
connector.
Note:
marking on connector for proper pin numbers.
1.1.6
Leave the Column Oven Motor Assembly on the fixture and move to wire rack for drying. Remove the Column Oven Motor
Assembly from the fixture after drying overnight and secure Shipping Bracket, 03-933199-01 using two 10-32 Keps Nuts,
13-3120060-00 as shown.
