DOC: DIMMPC
DESC:
DIMMPC Programming Procedures
PAGE:
REV
2 of 2
1
PREPARED BY: Sax Makthepharack REVISED BY:
CONTROL: INDUSTRIAL ENGINEERING
REV. DATE:
SHOWN
-
10 - 25 -00
Bob Jolley
1.2.2
Under ’STANDARD SETUP" depress the "ENTER" key. Using the "right arrow" key, move over to the "FLOPPY A" Icon and depress the
"ENTER" key again.
1.2.3
A box entitled "FLOPPY A" should appear on the monitor with the "NOT INSTALLED" box highlighted. Depress the "down arrow" key four
times until the "1.44 MB 3 1/2" " box is highlighted and depress "ENTER".
1.2.4
Depress the "ESC" key twice, (to the save and exit box) and then depress the "ENTER" key.
1.2.5
Continue steps 1.1.3 through 1.1.9 (omitting step 1.1.8) of the programming procedure.
