161
® 2018 Valco Companies, Inc.
In order to make changes to an existing Parameter Set, the Parameter Set needs to be loaded into memory.
Use the steps in "Changing Parameter Sets" starting on page 160 to load the Parameter Set you want to change
into memory.
When you load a Parameter Set into memory, the controller will use the loaded Parameter Set to
control the devices. It is not possible to make changes to one Parameter Set, while another Set is
controlling the devices.
The Options password is found by:
1. Press the
SYSTEM SETUP
key.
2. Press the
RIGHT
Arrow key.
3. Press the
UP
Arrow key.
4. Press
ENTER
to change the password.
a. Use the
PLUS or MINUS
keys to change the number under the cursor and the
LEFT
or
RIGHT
Arrow keys to
change the cursor position.
5. Press
ENTER
again to save the password.
It is possible to set an 8-number password to prevent unauthorized people from accessing the Startup options and
from copying or changing Parameter Sets. When this password is set and
ENTER
is pressed when the "Press
ENTER
to change" screen appears, the correct password needs to be entered or the controller will not allow access to the
startup options. To enter the password use the
PLUS
or
MINUS
keys to change the number under the cursor and the
LEFT
or
RIGHT
Arrow keys to change the cursor position.
A security level of 7 is needed to view and change the Options password.
Editing an Existing Parameter Set
ENTER
+
-
or
SYSTEM
SETUP
ENTER
or
Password for Parameter Set Options
*
*
