V-TEK TM-403, User Manual, Page: 108 / 306

4-24 TM-403 User’s Guide
Configure HMI Settings D292106.7b.fm
a. To manually set the Place Actuator to
the correct nozzle height, press Place
Extend
b. Use a 2.5mm hex wrench to hold the
Actuator Adjustment Screw in place
from the bottom, while loosening the
Jam Nut on top of the Actuator
Adjustment Screw with an 8mm open
ended wrench . Lower the Nozzle until
the part is barely touching the top of
the pocket in the
Place Location .
c. Tighten the Jam Nut .
d. Press Place Retract to retract the
Nozzle to a safe height.
e. Press the right Arrow Key to move to
the next Job Wizard screen.
12. Set Rotation Angle
a. Press the Placement Rotation Angle field to toggle through the rotation
options. The options are 0, -90 and +90. Select the correct placement angle.
Step 6:
Setup HMI
NOZZLE