V-TEK TM-403, User Manual, Page: 62 / 306

3-20 TM-403 User’s Guide
Job Tab D292106.6b.fm
A. Test the job settings, using the Pick Part and Place Part buttons to pick and place
parts.
B. If adjustment are required, use the left Arrow key to return to the desired step and
adjust settings until the TM-403 picks and places parts as desired.
15. Press the right Arrow Key to move to the next Job Wizard screen.
A. Set the Camera State to Enabled/Disabled as desired.
B. If the camera is Enabled , enter the number of pockets between the Place point
and the Inspection point in the Parts Until Inspection field. Begin the count with
the Place position as 0 so the Place pocket is not included in the count.
A
B
Job Wizard Step 15