V-TEK TM-403, User Manual, Page: 119 / 306

D292106.16c.fm Connect Vision
Chapter 5: Setup 5- 3
Connect Vision
Note: The TM-403 vision system can be run with a computer or a Keyence IV-G
Monitor. These options are not included with the TM-403. They can be purchased
separately from V-TEK, Inc. or the user may provide their own computer.
System requirements for the vision computer follow:
• Operating system: Microsoft® Windows XP
TM
(32 bit), Windows Vista
TM
(32bit),
or Windows 7
TM
(32 or 64 bit)
• 128 MB RAM
• 1024 x 768 (96 DPI) or 1280 x 1024 (120 DPI display
• Ethernet port
If vision is enabled for a job, the vision computer/monitor must be connected to the
Key-
ence IV-G Camera
and the camera must be trained to inspect the part before the job can
be run.
Setup HMI
Follow the steps below to enable Vision Inspection on the TM-403.
1. On the TM-403 HMI, open the
Taper Tab
. Press the right Arrow button to advance
to the second
Taper
screen. Ensure the
Camera State
is set to Enabled.
2. Using the M12 ethernet cable which was provided with the TM-403 system,
connect the vision computer to the Keyence camera.
Step 1:
Vision
Setup
CONNECT