V-TEK TM-403, User Manual, Page: 105 / 306

D292106.7b.fm Configure HMI Settings
Chapter 4: Setup 4- 21
c. Press Rotate to turn the nozzle so the set screw is accessible.
d. Use a 2.5mm hex wrench to hold the
Actuator Adjustment Screw in place from
the bottom, while loosening the Jam Nut
on top of the Actuator Adjustment Screw
with an 8mm open ended wrench . Raise
the Nozzle until it is at a safe height so it
will not collide with the current part when
extended.
e. Tighten the Jam Nut .
f. Press the Pick Extend button .
g. Loosen the Jam Nut on top of the Actuator Adjustment Screw again, then
lower the Nozzle until it is barely touching the part in the Pick Location .
Note : For all Nozzle Tips except the Convum Tips , the pick position should be set
just above the surface of the part with a very small clearance between the nozzle
and the part. Because the
Convum Nozzle Tips are flexible, it is all right if the tip is
programmed to touch the part when picking.
h. Tighten the Jam Nut .
i. Press Pick Retract to retract the Nozzle to a safe height.
j. Press Rotate to return the Nozzle to its original orientation.
k. Use the Index arrow keys to move the pick head back to the Tray 1, Pocket 1
position.
l. Press the right Arrow to move to the next Job Wizard screen.
Step 6:
Setup HMI
NOZZLE