V-TEK TM-403, User Manual, Page: 67 / 306

D292106.6b.fm Taper Tab
Chapter 3: Human Machine Interface 3-25
4. Pressing the right Arrow button in the third Taper Setup screens opens the final Taper
Setup screen. The fourth Taper Setup screen focuses on Leader and Sensor settings.
A. The Tape Jam Sensor Enabled/Disabled button turns the Tape Jam Sensor on
and off. The Tape Jam Sensor registers a tape jam whenever something pro-
trudes above the top of the carrier tape pocket. This might be caused by a mis-
placed part, a pocket that has been loaded with two parts or by a buckle in the
tape.
When the Tape Jam Sensor is on, the job that is being run is paused and an error
message appears on the HMI screen. The recommended setting for the Tape Jam
Sensor is Enabled .
The Low Cover Sensor Enabled/Disabled button turns the Low Cover Tape Sen-
sor on and off. The Low Cover Tape Sensor detects when the cover tape reel is
running low. When the Low Cover Tape Sensor is on, an error message appears
on the HMI screen. The recommended setting for the Low Cover Tape Sensor is
Enabled .
Note: The Low Cover error message is only displayed once during a job.
B. When Leader State is Enabled , the TM-403 will create a leader of the specified
Length at the end of the job.
The Leader Length field is only active when Leader State is Enabled . Enter the
desired leader length in millimeters in the field.
Note: The TM-403 will use these settings for the current job. To save Taper Settings for
future jobs, go to the Job Tab, select a job name and Save .
Taper Screen 4
A
B