D292104.7a.fm
Configure HMI Settings
Chapter 4: Setup
4- 25
13.
Verify Job Settings
Test the job settings, using the
Pick Part
and
Place Part
buttons to pick and
place parts. If adjustments are required, use the left
Arrow
key to return to the
desired step and adjust settings. Press the right
Arrow Key
to move to the next
Job Wizard
screen.
Note:
Manually placed parts will be counted in the current job.
14.
Vision Settings
a.
Set
Camera State
to
ON ( I )
or
OFF (O)
.
b.
If camera is enabled, enter number of
Parts Until Inspection
(do not include
part at Pick point.). Press the right
Arrow Key
to move to the final
Job Wizard
screen
Summary of Contents for TM-401
