4-2
TM-401 User’s Guide
Quick Start: Setup
D292104.7a.fm
Quick Start: Setup
The following is an outline of the basic steps required to setup the TM-401 for operation.
More detailed instructions follow in the next section of this chapter.
Caution:
Users should always wear protective eye wear when operat-
ing or maintaining the TM-401.
1.
Power up
• Power up the machine. Press
Reset
. Close all doors.
2.
Home the motors
• Press
Home Required
and
Home All Motors
.
3.
Load the Manual Tube Input Device (MTID)
• Ensure the correct
Tooling
for the part size to be processed is installed.
• Load components into the
Tube Feeder
.
4.
Install Nozzle
• Ensure correct nozzle size and tip are installed.
5.
Load Taper
• Load carrier tape.
• Load cover tape.
• Place an empty reel on the Take-up Arm.
6.
Configure HMI settings
• Go to the
Job Tab
and run the
Job Wizard
to configure job settings.
7.
Test Sealer
• Perform a Seal Test to ensure a good seal, adjust
Sealer
settings as necessary.
8.
Setup 2D Vision
• Connect Vision Computer
• Setup 2D Vision Inspection.
Summary of Contents for TM-401
