D292104.8a.fm
Quick Start: Running a Job
Chapter 6: Operation
6- 3
6.
Select Job.
• Open the
Job Tab
on the HMI. Select the desired job from the
Job Library
and
press
Open
to open the selected job in the
Run Tab
.
7.
Setup Vision.
• Open the
Taper Tab
on the HMI and advance to the second screen.
• Ensure camera is enabled. Configure inspection as needed.
Note:
To configure vision inspection, see
Chapter 4: Setup
.
8.
Run the Job.
• On the HMI, select the
Run Tab
then press
Run
.
• Load/unload parts and reels as needed.
Caution!
V-TEK® Incorporated takes no responsibility for the safety of TM-401 if it is
used for any purpose other than the intended purpose as specified in this
User’s Guide.
Quick
Start
Summary of Contents for TM-401
