D292104.16.fm
Connect Vision
Chapter 5: Setup
5- 9
Connect Keyence Monitor
Follow the steps below to connect the Keyence IV-G Camera to the Keyence Monitor.
(See previous section if using the Keyence computer.)
1.
Connect the Monitor's Ethernet cable to the Ethernet port on the back of the TM-
401
(A)
.
2.
Connect the Monitor's power cable to the power connection on the back of the TM-
401
(B)
.
3.
Turn the TM-401
ON
. The Keyence Monitor will automatically start and open the
Keyence software program.
4.
Select
Direct Connection
, then press
Connect
to establish a connection between
the Keyence Monitor and the Keyence Camera.
Step 1:
Vision
Setup
CONNECT
MONITOR
A B
Summary of Contents for TM-401
