7-2
TM-401 User’s Guide
Emergency Stop
D292104.9a.fm
Emergency Stop
The
Emergency Stop
Button
is located on the left
side of the TM-401.
If the
Emergency Stop
is pushed, the TM-401 will
automatically enter an
Emergency Stop
state.
When an
Emergency Stop
is triggered, the
Tower
Light
switches to red and all operations cease.
Activating an Emergency Stop
If emergency stop condition occurs, follow the steps below to resolve the
failure.
1.
Press the red
E-Stop
button to place the TM-401 into an
Emergency
Stop
state. The
Tower Light
will switch to red and all operations will
cease and the HMI will power off.
2.
Resolve the problem.(See tips on resolving error conditions which
follow.)
Clearing an Emergency Stop
To clear an
Emergency Stop
, follow the directions below.
1.
Twist the activated
Emergency Stop
button to turn it off and
release the button.
2.
Close all the doors on the TM-401.
Summary of Contents for TM-401
