V-TEK TM-401, User Manual

Page: 178 / 292

7-20 TM-401 User’s Guide
System Alarm Messages D292104.9a.fm
Error Message Table
Error Condition Solution
“The system was unable to suc-
cessfully pick from the feeder.” Nozzle is not picking parts from the Tube Feeder . Check
the following:
- Feeder is empty.
- Tube Feeder is jammed.
- Pick height is too high.
“The heat seal temperature is
not within range.” The Heat Sealer on the Taper has not reached the cor-
rect temperature. Wait until sealer has had enough time
to reach the correct temperature.
“The heat sealer was disabled
due to inactivity.” The Heat Sealer on the Taper was automatically disabled
after being inactive for more than 40 minutes. Wait until
sealer has had enough time to reach the correct temper-
ature, then proceed.
“The tape jam sensor has been
activated.” Check carrier tape prior to Sealer to ensure part is not
sticking out of pocket. Remove any obstructions, then
resume operation.
“The cover tape is running low.” Refill cover tape.
“A part has failed visual inspec-
tion in the carrier tape.” Check the following:
- Part is incorrectly oriented.
- Part
Mark is missing or obscured.
- Part is missing.
“The vision system has timed
out.” Check the following:
- Vision system is not connected to power
- Vision System is setup incorrectly.
“The last part picked was lost
between the pick and place
point.” Check the following:
-
Vacuum Sensor is set correctly.
- The correct Nozzle Tip is installed.
- Pick Position is centered correctly.
“The system has already placed
more parts than the entered
quantity.” The job quantity was changed after parts have been run.
Reset job or increase quantity.
“There’s not a part available to
place.” Pick a part and proceed.
“The job has been completed.
Reset the job to continue pro-
cessing.” Reset the job.