D292104.6.fm
Job Tab
Chapter 3: Human Machine Interface
3-15
In the photo below, a part is shown at the pick position as viewed from the front of
the machine.
• If rotation is set at
0
, the part will be placed in the same orientation as it was
picked.
• If rotation is set at
-90
, the part will be rotated 90 degrees clockwise prior to
placement.
• If rotation is set at
+90
, the part will be rotated 90 degrees counter-clockwise
prior to placement.
Press the right
Arrow Key
to move to the next
Job Wizard
screen.
A.
Test the job settings, using the
Pick Part
and
Place Part
buttons to pick and place
parts.
B.
If adjustment are required, use the left
Arrow
key to return to the desired step and
adjust settings until the TM-401 picks and places parts as desired,
-90
0
+90
Rotation Options
Job Wizard Step 13
Summary of Contents for TM-401
