D292104.7a.fm
Power Up the System
Chapter 4: Setup
4- 3
Power Up the System
1.
Power up the machine by turning the
Main Power
control on the
lower right side of the cabinet to the
ON
position.
2.
Press the
blue
Reset Button
on the left side of the machine.
There will be a brief popping sound as the
Air Dump Valve
releases air to the machine. As the TM-401 powers up the PLC,
Servo Drivers and HMI Monitor will boot up. On top of the
machine, the
Tower Light
will flash red indicating the machine is
on but not running.
Note
: The boot up process takes approximately 90 seconds.
The monitor will display the HMI
Job Tab
with a red
Home Required
message at
the top of the
Tab Menu
..
Step 1:
Power
Up
Summary of Contents for TM-401
