3-10
TM-401 User’s Guide
Job Tab
D292104.6.fm
The fifth
Job Wizard screen
is used to enter the number of tubes that will be loaded in the
MTID.
A.
Enter the number of tubes that will be processed. If two
Tube Feeders
are
installed, this will include the total number of tubes to be processed from both
feeders.
B.
Enter the maximum number of tubes a single feeder will hold, then press the right
Arrow Key
to move to the next
Job Wizard
screen.
The sixth and seventh
Job Wizard screens
are used to automatically determine Tube
Pitch.
A
B
Job Wizard Step 5
A
C
Job Wizard Step 6
B
Summary of Contents for TM-401
