UTT Technologies Chapter 3 Quick Setup
http://www.uttglobal.com
Page 29
User Name:
It specifies the user name used for PPP authentication.
Password:
It specifies the password used for PPP authentication.
Back:
Click to go back to the previous page of the
Setup Wizard
.
Cancel:
Click to revert to the last saved settings.
Exit:
Click to exit the
Setup Wizard
and go to the
Welcome
page (see Figure 3-5).
The changes made in the
Setup Wizard
will be discarded.
Skip:
Click to go directly to the next page of the
Setup Wizard
. The changes made
on the current page will be discarded.
Next:
Click to go to the next page of the
Setup Wizard
.
Note
It is strongly recommended that you configure only the
3G USB Modem
and
ISP
of
the 3G Internet connection, and leave the other parameters at their default values. If
necessary, please change them under the guidance of a professional.
3.3.3.3 APClient Internet Connection Settings
In the
Setup Wizard - APClient Connection Settings
page, the security settings depend
on the value of
Security Mode
. The following sections describe the APClient connection
settings under each security mode respectively.
3.3.3.3.1 APClient Connection Settings - Disabling Wireless Security
Figure 3-11 Setup Wizard - APClient Connection Settings (Disabling Wireless Security)
AP SSID:
It specifies the SSID of the remote AP. It must be between 1 and 32
characters long, and it is case sensitive.
AP MAC Address:
It specifies the MAC address of the remote AP.
Security Mode:
It specifies the security mode to be used by the Wireless Router.
