UTT Technologies Chapter 3 Quick Setup
http://www.uttglobal.com
Page 19
Chapter 3 Quick Setup
This chapter describes how to properly configure TCP/IP settings on your computer, how to
login to the Wireless Router, and how to configure the basic parameters to quickly connect
the Wireless Router to the Internet via the
Start > Setup Wizard
. In addition,
it also briefly
describes the layout and style of the Wireless Router
’s Web UI.
3.1
Configuring Your Computer
Before configuring the Wireless Router via the Web UI, you should properly configure
TCP/IP settings on the computer that you use to administer the Wireless Router. To do this,
follow these steps:
Step 1
Connect the computer to a LAN port of the Wireless Router.
Step 2
Install TCP/IP protocol on your computer. If it has been installed, please ignore
it.
Step 3
Configure TCP/IP settings on your computer: set the computer’s IP address to
an IP address in the range of 192.168.1.2 through 192.168.1.254, set its subnet
mask to 255.255.255.0, set its default gateway to 192.168.16.1 (the Wireless
Router
’s default LAN IP address is 192.168.1.1 with a subnet mask of
255.255.255.0), and set its DNS server to an available IP address provided by
your ISP.
Step 4
To verify the network connection between your computer and the Wireless
Router, you can use the ping command at the command prompt on the
computer:
Ping 192.168.1.1
If the displayed page is similar to the screenshot below, the connection
between your computer and the Wireless Router has been established.