Unipulse TM380, Operation Manual

Page: 66 / 147

55
7 EXPLANATION OF HOLD FUNCTIONS
55
EX
PLANATION OF HOLD FUNCTIONS
Chapter
7
7-1.
Hold functions of torque
The hold functions are to take out a specific point of torque for HI/LO limit comparison. Here, the
operation of each hold will be described in detail.
■
Flow of hold measurement
1.
Select a hold you want to use.
2.
If the hold has the setting of section, set a section you want to use.
For details, see "7-3.Setting of hold section" on page 61.
3.
Set the special setting value required for the hold used.
4.
After confirmation of wiring, perform hold control by external input etc., and start
measurement.
7-2.
Setting of hold mode
■
Hold mode setting method
1.
Select setting mode 1.
Press once.
2.
Set "Hold mode."
Press seven times ⇒ "Hold function select " is
displayed.
Press , and the highest digit blinks.
Move to the lower digits with .
Input the setting value with .
(Initial value: 0)
Validate it with .
3.
Press twice to go back to the indicated value
display.
Hold mode Hold section
0: OFF
None
1: Sample 0: All section 1: External signal
2: Peak
0: All section
1: External signal
2: External Time
3: Level+Time
3: Bottom
4: P-P
5: Average
6: Peak (angle)
6: Peak (angle + torque)
7
EXPLANATION OF
HOLD FUNCTIONS
Speed
rpm
Angle rad deg
FNC
Torque
Speed
rpm
Nm
H I LO HOLD
Angle rad deg
《 Setting value 》
Hold section
Undefined
0 0 0 1
Auto reset
Hold mode
0: OFF
2: Peak
4: P-P
6: Peak (angle)
1: Sample
3: Bottom
5: Average
7: Peak (angle + torque)
RECALL
RECALL
ESC