F3200/NDU AS4428.1 Installation Manual
Document No: LT0255
Applications
Page 6-8
5 July 2016
Issue 1.22
Each of these circuit arrangements can be achieved using the KT0113 kit
– follow the
assembly instructions supplied (LT0438). The board supplied in the kit must be modified as
per the installation instructions to give circuit type 3 operation (2 outputs as per Figure
6.1.6B and shown on wiring diagram 1945-19-3) or type 4 operation (3 outputs as per Figure
6.1.6A and shown on wiring diagram 1945-19-4).
The KT0113 may be supplied in one of two formats -
“A” and “B”. Format “A” has solder
connections down both sides. Connections should be made to the RH side pads viewed
from pcb rear. Ignore the LH side pads.
See Tables 1 and 2 for connections (functions).
TABLE 1
CONNECTION / FUNCTION TABLE (TYPE 3 CCT)
BD TYPE A
TERMINAL
BD TYPE B
TERMINAL
FUNCTION
WIRE
COLOUR
+24V (J19)
+24V (J33)
+24V
RED
GRN (J20)
GRN (J34)
UNUSED
YEL (J21)
YEL (J35)
YELLOW “FAULT” LED O/C
YELLOW
RED (J22)
RED (J36)
RED “RUN” O/C
BLUE
SW (J23)
SW (J37)
SWITCH I/P
BROWN
0VA (J24)
0VA (J38)
0VA (SWITCH COMMON)
BLACK
0VL (J25)
0VL (J39)
0VL (GREEN “STOP” LED)
BLACK
MX1-A (J44)
MX1-A (J50)
UNUSED
MX1-B (J45)
MX1-B (J51)
UNUSED
MX1-C (J46)
MX1-C (J52)
UNUSED
NOTE:
ON BD TYPE A, TERMINALS J26-J32 & J47-J49 ON LHS ARE NOT USED.
BD TYPE A IS IDENTIFIABLE BY HAVING SOLDER CONNECTIONS DOWN
BOTH SIDES.
TABLE 2
CONNECTION / FUNCTION TABLE (TYPE 4 CCT)
BD TYPE A
TERMINAL
BD TYPE B
TERMINAL
FUNCTION
WIRE
COLOUR
+24V (J19)
+24V (J33)
+24V
RED
GRN (J20)
GRN (J34)
GREEN “STOP” LED O/C
GREEN
YEL (J21)
YEL (J35)
YELLOW “FAULT” LED O/C
YELLOW
RED (J22)
RED (J36)
RED “RUN” O/C
BLUE
SW (J23)
SW (J37)
SWITCH I/P
BROWN
0VA (J24)
0VA (J38)
OVA (SWITCH COMMON)
BLACK
0VL (J25)
0VL (J39)
UNUSED
MX1-A (J44)
MX1-A (J50)
UNUSED
MX1-B (J45)
MX1-B (J51)
UNUSED
MX1-C (J46)
MX1-C (J52)
UNUSED
NOTE:
ON BD TYPE A, TERMINALS J26-J32 & J47-J49 ON LHS ARE NOT USED.
BD TYPE A IS IDENTIFIABLE BY HAVING SOLDER CONNECTIONS DOWN
BOTH SIDES.
