Configuration Guide
78
Managing Physical Interfaces
Basic Parameters Configurations
2
Basic Parameters Configurations
2.1 Using the GUI
Choose the menu
Switching > Port > Port Config
to load the following page.
Figure 2-1
Configuring Basic Parameters
Follow these steps to set basic parameters for ports:
Select and configure your desired ports or LAGs. Then click
Apply
.
Jumbo
For T1600G-18TS, you can set the MTU (Maximum Transmission Unit) size for frames
globally as needed. The valid values are from 1518 to 9216 bytes, and the default is
1518 bytes.
For other T1600G series switches, you can enable or disable Jumbo on the port. For
the port with Jumbo enabled, the MTU size is up to 9216 bytes, thus allowing the port
to send jumbo frames. By default, it is disabled and the MTU size for frames received
and sent on the port is 1518 bytes.
UNIT:1/LAGS
Click
1
to configure physical ports. Click
LAGS
to configure LAGs.
Type
Displays the port type.
Copper
indicates an Ethernet port, and
SFP
or
SFP+
indicates
a fiber port.
